25-210875-1X Drive Shaft Center Support Bearing, New

Product Overview

25-210875-1X Drive Shaft Center Support Bearing is intended for center support service on selected 1760 / 1810-series drive shaft assemblies. The support bearing carries the intermediate shaft section, while the rubber carrier helps isolate vibration and allows controlled movement as the driveline works under load. A worn support can contribute to thumping, vibration, rubber separation, bearing noise, or visible shaft movement.

This new independent aftermarket replacement is supplied for professional driveline repair. Its 26 support configuration must be compared with the removed unit because bracket geometry and bearing position affect shaft alignment.

Structured Product Data

Service and Fitment Guidance

Confirm the reference number, driveline series, bearing inside diameter, centerline height, bracket width, mounting-center distance, bolt-hole diameter, and rubber-carrier layout. Measure the removed support with the shaft unloaded and compare the bracket from the same orientation. Do not rely on vehicle year or series alone.

• Inspect the shaft tube, slip section, universal joints, fasteners, bearing journal, and mating surfaces before assembly.
• Keep the driveline phased and indexed as required by current service information; incorrect alignment can create vibration.
• Use proper bearing tools and torque procedures. Installation should be completed by a qualified driveline technician.

FAQ

Is 25-210875-1X a genuine branded part?

No. This is an independent aftermarket replacement compatible with selected Dana / Spicer applications. These names and reference numbers are used solely for identification and compatibility comparison; no affiliation, authorization, sponsorship, or endorsement is claimed.

How do I confirm exact compatibility?

Match 25-210875-1X, the driveline series, component position, mounting or spline dimensions, yoke or bracket style, and the complete physical design of the removed part. Vehicle year and model alone are not sufficient.

Which details should I compare before ordering?

Compare the structured dimensions below, then inspect the mating shaft, support location, bolt pattern, spline profile, wear surfaces, and installation clearances. Stop if any measured detail differs.

Trademark and Non-Affiliation Notice

All third-party brand names, model designations, logos, and part numbers are the property of their respective owners. They are used solely for identification and compatibility reference. This independently supplied aftermarket replacement is not an OEM or genuine branded product and is not manufactured, authorized, licensed, sponsored, affiliated with, or endorsed by any referenced trademark owner.